4

I have setup a full node myself and made sure the attachToTangle command is remotely available. I was assuming the IOTA wallet would outsource its PoW then instead of doing it himself (by means of CCurl or Webgl).

But my transactions do not seem faster? How come?

Improve this question
2
  • 1
    The wallet does always do the POW by default as far as I know. Don't know of a way to outsource it to the node (there are very few nodes who allow that anyway). Might be possible with the command line wallet.
    – Werner der Champ
    Commented Jan 2, 2018 at 23:51
  • @WernerderChamp i think you are right. this related question affirms. it would be nice though to make this also configurable in the GUI wallet.
    – GJEEE
    Commented Jan 2, 2018 at 23:56

2 Answers 2

Reset to default
2

On the Desktop GUI wallet, as far as I know there is no way to set PoW to be done on the fullnode. But the Cli Wallet and the Android Wallet the default PoW is done on the fullnode.

Improve this answer
0

Official gui wallet will do PoW on the full node if it's on localhost (address in config is http://localhost:14265). If you have a remote node you can use it as local by making ssh tunnel to it so it is accessible on localhost:14265 address.

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.